Home / Hardness converter

Hardness converter

Lab reports often list hardness in milligrams per liter or parts per million. Softener manuals usually want grains per gallon. This page converts both ways, then classifies the result with the USGS ranges.

Your hardness test

1 grain per gallon = 17.1 ppm or mg/L, the usual rounded value. Maryland Geological Survey states the unrounded figure as 17.118 mg/L. Connecticut Department of Public Health uses 17.1. Penn State Extension rounds more loosely to "approximately 17" mg/L. This page uses 17.1.

Iron adjustment (optional)

Compensated hardness = hardness in gpg + (iron in ppm x multiplier). The starting multiplier of 4 is from the University of Minnesota Water Resources Center. It is a planning factor, not a laboratory identity, so you can change it.

The conversion and the USGS classes

This site uses 17.1 ppm (mg/L as calcium carbonate) per grain per gallon. Maryland Geological Survey states that 1 gpg equals 17.118 mg/L. Connecticut Department of Public Health's hardness fact sheet uses the rounded value 17.1. The difference is about one tenth of one percent and does not change ordinary household sizing.

The U.S. Geological Survey Water Science School gives these general guidelines, as mg/L as calcium carbonate: 0 to 60 is soft; 61 to 120 is moderately hard; 121 to 180 is hard; more than 180 is very hard. Converted at 17.1, those ranges are about 0.00 to 3.51 gpg (soft), 3.57 to 7.02 gpg (moderately hard), 7.08 to 10.53 gpg (hard), and more than 10.53 gpg (very hard).

Some state and extension tables add a "slightly hard" band below 60 mg/L (for example Penn State Extension and the Connecticut fact sheet). Those five-band tables are not the USGS guidelines used on this page. The 17.1 conversion still applies.

Worked examples

171 ppm divided by 17.1 is exactly 10 gpg. 171 mg/L falls in the USGS hard band (121 to 180). Going the other way, 10 gpg times 17.1 is 171 ppm.

The USGS very-hard threshold of more than 180 mg/L is more than 10.53 gpg. The top of the soft band, 60 mg/L, is 3.51 gpg.

Sources

Common questions

Is ppm the same as mg/L for hardness?

For this kind of water test, yes. Hardness in milligrams per liter as calcium carbonate is treated as equal to parts per million. NDSU Extension and Maryland Geological Survey both state that equivalence.

Why does my water report use a different class name?

Classification schemes differ. This page follows the four USGS bands. Some health departments and extension services split the soft end into "soft" and "slightly hard." The milligram-per-liter number does not change; only the label does.

Should I convert before or after the iron adjustment?

Convert the measured hardness first, then add iron times the multiplier, in grains per gallon. That is the compensated hardness a sizing calculation uses.

Estimates only. These tools are for planning, not a quote, a water test, or professional advice. Confirm hardness and iron with a laboratory or your water quality report. Compare the grain result to the capacity listed in the unit's manual at the salt dose you will actually use, which is often lower than the number printed on the box. This site does not sell equipment or take a cut from any brand.

By James Johnston. Updated November 2026. Estimates for planning, not advice. See sources and method.